Tuesday, September 20, 2011

Port Forward Fuel Tank Goes In

Lots of rewiring today. Actually, it's mostly just cleaning up wires that are already there. Got the the new port forward fuel tank in. Sure glad the height of the tank was reduced by 1/2". Even so, had to use the hydraulic jack on the settee.

IMG_1804.JPG

The new tanks are delivered to the dock. Now just installation remains …

IMG_1805.JPG

These stainless screws were holding the bilge pump down. Note how the bilge water has eaten them away. The head of the screw was tight against the plastic pump case. The water trapped below it was probably stagnant and stainless will corrode badly in deoxygenated water.

IMG_1809.JPG

The port forward fuel tank is back in place.

Monday, September 19, 2011

Fuel Tank Vent Blockage

The port vent line had a low point (i.e. p-trap) where it penetrated into the bilge. Drilled 3/16" holes in the floor joists and then nylon-tied the 3/4" vent hose tightly to the bottom of the joist. Had to replace the 1100 gpm main bilge pump as one of the plastic tabs which held it into the strainer had broken off.

Saturday, September 10, 2011

Port Bulwark is Retaining Water

Good news. Rebedding the starboard fuel fill plate worked as no water is leaking by it. The port bulwark is getting water inside it. Probably via the hawse pipe to bulwark joint. The water is then dripping below decks via a pinhole leak in the fiberglass. The pinhole leak is 3" outboard of the port fuel fill.

Thursday, August 18, 2011

Fuel Filler Ports--Bad Location

I replaced the 1-1/2" manual bilge pump hose today and was pleasantly surprised that it wasn't all that hard to get to. Also replaced the 1-1/8" aft bilge pump hose. Pulled the fuel filler hoses off too, or more accurately had to use a Dremel tool to cut through the hose where it attached to the filler neck. Tried a heat gun first without success. Those hoses have tenacious holding power. The fuel filler port on the starboard side was the source of water getting below deck. The yard couldn't have put the filler ports in a worse spot—essentially the deck's low point. Water from both the bow and stern run towards the filler port. I couldn't tell if the water was getting by the joint between the filler port and teak, or the joint between the teak and fiberglass. It was obvious when I pressed down on the area around the filler port that water was under the teak deck. Re-bedded and painted the starboard side fuel filler port.

Wednesday, August 17, 2011

Fuel Deck Fill Re-Bed

Removed the port side fuel deck fill and re-bedded it. Removed the 1-1/8" x 11' hose from the aft bilge pump. Removed the 1-1/2" x 4' hose from the manual bilge pump. Andy Bloodsworth finished building the port forward fuel tank.

Monday, August 15, 2011

Sunday, August 14, 2011